1.Let's make the animation that shakes a flag. Movement is attached to a flag object on layout. What kind of move even with good although, at this time important is that pole of movement be, cloth of part wa MD with movement obj attached because how may although, pole to entangled not such movement of one sbj unnatural become not good may. is the a the an it it is it that and as for is be I make movement that rotates 1 around. A sample be flag2.lws.

2.Triggering the generic plug-in MD_Capture that is registered if movement are completed the movement of an object begins to be scratched. It designate a file name . When OK is pushed a file is produced. Sample flag.mox

3.It triggers MDS and read a flag object from file>load lwo.

4.File>motion of object motion file flag.mox that prepared a little while ago Read from load.

5.Let's set up parameters needed for each surfaces. A Dialog sends be set up from setup>suface. A pole part moves forcibly in accordance with the movement of an object in this case, even if it says with (fixation so as not to move), a cloth part sets up hard of spring coefficient 1000 . Spring coefficient of (air)resistance=5, hold structure, although even only this moves the parameter of a cloth part as=1000 it becomes (a spring coefficient of back-up structure), prepare supplementary structure in addition to (the polygon of a designated surface back-up structure on and become be near the image of cloth that catches and moves air, by designating) a surface makes difficult to turn break.

 

7.Let's carry out and calculation. When OK is done and a calculation Dialog is displayed with  button on the tool bar calculation is started. It can go to have it to a center with  button in the case that an object went beyond it from a screen. Also polygon display mode Of the part and back-up structure that are doing structure calculation, by selecting line display mode  instead it confirms able to.

8. If setting are correct, a flag should be shaken on a screen. Because it stops when designated calculation time finishes Try to replay with a button. If I do not like it changing a parameter it is calculation.

9. The result that calculated it is preserved to a file. Designating a file name with file > motion save it is preservation. A sample be flag2.mdd.

10.Triggering layout, I read a flag object. Furthermore to a displacement plug-in MD I read the file that preserved from Option and select Plug. Also, to cut the movement on the side of layout, because movement itself is interwoven to mdd file and take in the movement of an object to MD side this time MOVE Off switch is turned on. It becomes abnormal movement because movement is added twice, in the case that it does not turn on it. A scene file of a sample be flag2e.lws.

11.It should be transformed, in the range where it designated when time sliders are moved.